Five sloper holds. Selection of best holds from archived sets of holds. Fastened with capheaded or countersunk bolts M10 (dual system).
Bolts are not included.
Six pockets holds. Selection of best holds from archived sets of holds. Fastened with capheaded or countersunk bolts M10 (dual system).
Bolts are not included.
One big ring hold. Crater 2 is slopy more then crimpy inside.
Fastened with capheaded or countersunk bolts M10 (dual system) or with three screews .
Bolts are not included.
One big, rounded square shapes hold. This hold is often used for bouldering competitions.
Fastened with capheaded or countersunk bolt M10 (dual system) and one screw.
Bolts are not included.
One big sloper shaped by Rober Leistner. Fastened with capheaded or countersunk bolts M10 x 150 (dual system) and screws.
Bolts are not included. Warning: Bolt M10 x 150!
Ten small, positive crimps suitable for strong fingers. Old climbing holds again in production. Fastened with capheaded or countersunk bolts M10 (dual system).
Bolts are not included.
Ten small crimps, maybe little sharp, suitable for strong fingers. Old climbing holds again in production. Fastened with capheaded or countersunk bolts M10 (dual system).
Bolts are not included.
Ten small crimps, suitable for system boards and bouldering. Holds are axially symmetric. Old climbing holds again in production. Fastened with capheaded or countersunk bolts M10 (dual system).
Bolts are not included.
You will try to use thumb during climbing on this ten crimp holds. Fastened with capheaded or countersunk bolts M10 (dual system) and screws.
Bolts are not included.
Ten crimps holds. On these climbing holds you will try push your fingers deeper inside. Fastened with capheaded or countersunk bolts M10 (dual system) and screws.
Bolts are not included.
Eight slopy crimp holds with border line on surface. One side of hold is flat and suitable for mounting screw holds. Fastened with capheaded or countersunk bolts M10 (dual system) and screws.
Bolts are not included.
One big slopy crimp hold with border line on surface. One side of climbing hold is flat and suitable for mounting screw holds. Fastened with capheaded or countersunk bolts M10 (dual system) and screws.
Bolts are not...